CipherLab 1166 Manuel d'utilisateur télécharger pdf (Page 5)

Page 5 of 5

Continuous mode (non trigger use) with Auto power off mode

NOTE: 1266 Laser Scanners only. Never set a 1266 Laser Scanner to “Continuous Mode”.

Use “Auto Power Off Mode” as above with a maximum Time-out period of 30 seconds.

When you are confident with the scanning distance, you may wish to change to a continuous type mode. Fully

“Continuous Mode” may chew up the battery and therefore Auto Power Off Mode is recommended. The scanner will

stay continuous while in use. Non-use for a certain period (default is 10 seconds) puts the scanner to sleep. Press

trigger to reawaken.

Step Action Barcode

Scan Enter Setup

Scan Auto Power Off Mode

Scan Update

Changing Scanner Time-out Duration

You may prefer a period longer than 10 seconds, before the scanner turns itself off,

For Example: Time-out period to be 30 seconds.

Step Action Barcode

Scan Enter Setup

Scan Scanner Time-out Duration

Scan two Decimal Digits barcodes below for the time

required. If 30 seconds required scan 3, then 0. (99

seconds is maximum).

See Decimal Digits table below

Scan Validate

Scan Update

Decimal Digits:

1 2 3 4 5 6

Pas de commentaire

CipherLab 1166 Manuel d'utilisateur Page 5