CipherLab 1266 Guide de l'utilisateur télécharger pdf (Page 59)

Chapter 3 Changing Symbology Settings

3.16 TELEPEN

Select the check box so that the scanner can read Telepen barcodes.

 Advanced settings are provided as shown below.

Telepen Full ASCII or Numeric

Select whether AIM Telepen (Full ASCII) or Original Telepen (Numeric) is supported.

Apply Editing Format

Select the check box to apply editing format to Telepen, if there is any. Refer to 5.2.1 Applicable

Conditions

Note: Telepen is not supported on the 14XX module.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 91 92

RELEASE NOTES 3
CONTENTS 5
INTRODUCTION 9
USING SCANMANAGER 10
Introduction 11
SETUP BARCODES 12
SCANNER INFORMATION 14
MENU BAR 15
FILE MENU 15
ScanManager User Guide 16
DOWNLOAD MENU 17
HELP MENU 18
Chapter 1 21
IN THIS CHAPTER 22
1.1 SCANNING MODE 23
1.3 STATUS INDICATOR 27
1.3.1 BUZZER 27
1.3.2 GOOD READ LED 27
Chapter 2 29
2.1 KEYBOARD WEDGE 31
2.1.1 KEYBOARD TYPE 31
2.1.2 ALTERNATE COMPOSING 32
2.1.3 ALPHABETS TRANSMISSION 32
2.1.4 DIGITS TRANSMISSION 33
2.1.5 CAPITAL LOCK TYPE 33
2.1.6 CAPITAL LOCK STATE 33
2.1.7 ALPHABETS LAYOUT 34
2.1.8 DIGITS LAYOUT 35
2.1.9 LAPTOP SUPPORT 35
2.1.10 INTER-CHARACTER DELAY 36
2.2 RS-232 37
2.2.1 TRANSMISSION MODE 37
2.2.2 BAUD RATE 37
2.2.3 DATA BITS 37
2.2.4 PARITY 38
2.2.5 FLOW CONTROL 38
2.2.6 INTER-CHARACTER DELAY 38
2.3 WAND EMULATION 39
2.3.1 MARGIN TIME 39
2.3.2 MODULE TIME 39
2.3.3 NORMAL STATE 40
2.3.4 BAR STATE 40
2.4 BT SERIAL PORT 41
2.4.1 AUTHENTICATION 41
Chapter 3 43
3.1 CODABAR 45
3.2 CODE 25 — INDUSTRIAL 25 46
3.3 CODE 25 — INTERLEAVED 25 47
3.4 CODE 25 — MATRIX 25 48
3.5 CODE 39 49
3.6 CODE 93 50
3.7 CODE 128 50
3.10 GS1-128 (EAN-128) 53
3.11 MSI 54
3.12 FRENCH PHARMACODE 55
3.13 ITALIAN PHARMACODE 55
3.14 PLESSEY 56
Transmit Check Digit 58
3.16 TELEPEN 59
Chapter 4 63
4.1 CHARACTER SUBSTITUTION 64
4.2 PREFIX/SUFFIX CODE 65
 Prefix Code: None 65
4.3 CODE ID 67
4.3.1 CODE ID SET 1~5 68
4.4 LENGTH CODE 70
Chapter 5 71
5.1 FORMAT SELECTION 72
5.1.1 ENABLE EDITING FORMATS 72
5.1.2 EXCLUSIVE DATA EDITING 72
5.2.2 FIELD SETTINGS 74
5.2.3 TRANSMISSION SEQUENCE 76
5.2.4 EXAMPLES 77
Appendix I 79
GRID CONTROL — SCAN CODE 81
Appendix II 83
1100/1105/1200 DEFAULTS 85
1160/1166/1260/1266 DEFAULTS 87
14XX DEFAULTS 89
1045 DEFAULTS 91

Commentaires sur ces manuels

Pas de commentaire

CipherLab 1266 Guide de l'utilisateur Page 59

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de codes-barres CipherLab 1266