CipherLab 1502 Guide de l'utilisateur télécharger pdf (Page 32)

Enter Setup

1500/1502 Barcode Scanner User Guide

1.6.5 AUTO POWER OFF MODE

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until the pre-set timeout expires, and, the pre-set timeout

period re-counts after each successful decoding.

Note: Refer to “Delay between Re-read” and “Scanning Timeout”.

1.6.6 AIMING MODE

The scanner will aim at a barcode once the trigger is pressed, and start scanning when

the trigger is pressed again within one second.

 The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout

expires.

Aiming Timeout

You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.

1. Read the label above to specify the time interval before aiming ends. (It is set to 1 by default.)

2. Read the “

Decimal Value” label on page 137. For example, read “1” and “0” for the scanner to

automatically shut down after being idle for 10 seconds.

3. Read the “Validate” label on the same page to complete this setting.

Auto Power Off Mode

iming Mode

Aiming Time-Out after

15 seconds (*1)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 149 150

Pas de commentaire

CipherLab 1502 Guide de l'utilisateur Page 32