CipherLab 1520 Guide de l'utilisateur télécharger pdf (Page 32)

MIRROR 5250 Emulator

User Guide

802.11b/g wireless network communications channel.

 Shared key authentication requires that the client configure a static WEP key.

The client access will be granted only if it passed a challenge based

authentication.

Note: For Shared Key authentication, the active WEP key is used for authentication.

3.4.2 WEP KEY

Select the check box to implement Wired Equivalent Privacy or Wireless Encryption

Protocol (WEP) for data encryption.

Setting

Remark

Key Length Encryption type can be 64 bits (5 bytes) or 128 bits (13 bytes).

 Using 64-bit encryption, the password phrase can be 5 characters long.

From the Grid Control, select up to 5 characters (ASCII codes) for the WEP

key.

 For 128-bit encryption, the password phrase can be 13 characters long.

From the Grid Control, select up to 13 characters (ASCII codes) for the WEP

key.

Key 1 ~ 4 Key index number. Up to four WEP keys can be configured.

Active Only one key (the active one) can be used at a time.

Note: You must use the same settings as configured for other devices on your wireless

network, e.g. access points.

3.4.3 WPA-PSK/WPA2-PSK PASSPHRASE

WPA-PSK is supported to enhance security over wireless networks, and this Pre-Shared

key mode requires a passphrase to access the network. The passphrase must be 8 to 63

characters (ASCII codes). It is used to generate a WEP key automatically.

 For 8400, it also supports WPA2-PSK!

3.4.4 EAP

Select the check box to enable authentication using Extensible Authentication Protocol

(EAP). It requires user name and password so that the mobile computer can identify

itself when associating to Cisco

access points.

Setting

Remark

Identity Specify a user name. (32 characters maximum)

Password Specify a password. (32 characters maximum)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 86 87

Pas de commentaire

CipherLab 1520 Guide de l'utilisateur Page 32