CipherLab 1562 Manuel d'utilisateur télécharger pdf (Page 3)

Note:-

1. To turn OFF the scanner, remove the battery

2. For shipping and storage purposes save the scanner and battery separately, this will

keep the battery in good condition. Remove the battery if the 3656 USB cable is

disconnected from the computer for any extended period of time.

3. When the battery charge becomes low the scanner will be unable to emit the scan

beam and its power-on beep will sound different to normal.

Initially the 1560/62 BT scanner will be have been configured by Dataman Barcode Systems

to communicate directly and immediately with the computer using the Cipher 3656 USB

Bluetooth communication stand.

The Cipher 3656 USB Bluetooth communication stand is connected to a vacant USB port on

the computer and sends the bar code data received from the 1560/62 directly to the

computer’s keyboard buffer so it appears as if it was typed from the keyboard.

Windows:- Once the USB interface cable and power supply cord has been fitted to the

Cipher 3656 Bluetooth communication stand as illustrated above connect the stand to a

vacant USB port on your computer, the host computer will often respond with a pop up text

balloon in the bottom right of the screen indicating “NEW USB Hardware found”.

Pairing:- In some cases where the 1560/62 BT has been programmatically reconfigured it

may be necessary to re-pair (bind) the 1560/62 BT unit with the 3656 communication stand.

Pairing (sometimes referred to as binding) is the process of respectively scanning both the

"Set Connection" bar code and the "Serial No" bar code located on the underside of the

3656 communication stand using the associated 1560/62 scanner unit. A rapidly flashing blue

light on the communication stand will indicate successful pairing.

The bar code reader is now ready to use, simply open the application that you require to

capture the bar code data and start scanning. For Windows users an ideal application to test

the scanner is “Notepad”, a small editor program located among Windows accessories.

Upon powering up the 1560/62 scanner will try to establish a connection with the 3656

communication stand.

How to scan with the Cipher 1560/62 BT Scanner:

• Hold the 1560/62 Scanner at an angle to the bar code approximately 10 – 15 degrees

• Position the 1560/62 Scanner between 8 – 18 cm from the bar code and press the scan key

• Scan beam must extend at least 1 cm beyond edges of bar code

• Slowly bring the 1560/62 closer to the bar code until a good read beep is achieved

1 2 3 4 5 6 7 8 ... 14 15

Pas de commentaire

CipherLab 1562 Manuel d'utilisateur Page 3