CipherLab 1266 Spécifications Page 35
- Page / 180
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
23
Update
Chapter 1
Understanding the Barcode Scanner
8 sec
Send Data
The 128 KB flash memory on the scanner can store up to 8,192 scans based on EAN-13 barcodes.
When it is used up, the scanner will respond with three short beeps (low tone) as a warning. You
are advised to send data to the server immediately by having the scanner read the barcode below.
1. Read the setup barcode to resume connection with host. (= disable Memory Mode)
2. Read the “Send Data” barcode.
*Disable
Send Data
Clear Data & Confirm
Even though data has been sent back to the server, the flash memory is still occupied unless you
erase the memory by having the scanner read two barcodes – “Clear Data” and “Confirm”.
1. Read the “Clear Data” barcode to clear the flash memory.
2. Read the “Confirm” barcode to confirm the action.
Clear Data
Confirm
- 1166 / 1266 Barcode Scanne 1
- IMPORTANT NOTICES 3
- RELEASE NOTES 5
- CONTENTS 7
- INTRODUCTION 13
- SETTING UP 3666 15
- DIRECT CHARGING 16
- Introduction 17
- SYMBOLOGIES SUPPORTED 18
- QUICK START 21
- ENTER CONFIGURATION MODE 23
- EXIT CONFIGURATION MODE 23
- DEFAULT SETTINGS 24
- RESTORE SYSTEM DEFAULTS 24
- Quick Start 25
- Refer to Appendix III 28
- LIST THE CURRENT SETTINGS 29
- Chapter 1 31
- 1.2 MEMORY 33
- 1.2.1 TRANSMIT BUFFER 33
- 1.2.2 MEMORY MODE 34
- Chapter 1 35
- 1.4.1 GOOD READ BEEP 38
- 1.4.2 FREQUENCY 38
- 1.5 SCAN MODES 39
- 1.6 SCANNING TIMEOUT 43
- Laser mode 43
- Auto Off mode 43
- Auto Power Off mode 43
- 1.9 NEGATIVE BARCODES 46
- Chapter 2 47
- 2.1 BT HID 48
- 2.1.2 RESET CONNECTION 49
- Chapter 2 51
- Selecting Output Interface 51
- 2.2 BT SPP SLAVE 58
- 2.3 KEYBOARD WEDGE VIA 3666 59
- Keyboard Wedge via 3666 60
- No. Keyboard Type No 60
- Keyboard Type 60
- 2.3.2 KEYBOARD SETTINGS 61
- US Keyboard Style – Normal 62
- 62
- Cap Lock Type Description 64
- Alphabets Transmission 66
- ALT Composing 68
- Laptop Support 68
- 2.3.3 INTER-CHARACTER DELAY 69
- 2.4 RS-232 VIA 3666 70
- 2.4.2 BAUD RATE 70
- 2.4.3 DATA BITS 71
- 2.4.4 PARITY 71
- 2.4.5 FLOW CONTROL 72
- 2.4.6 INTER-CHARACTER DELAY 72
- Chapter 3 73
- Set Connection 74
- 3.1.2 CHANGE INTERFACE 75
- Sniff Mode (Power-saving) 76
- 3.2 CONNECTING VIA BLUETOOTH 77
- 3.2.1 CHANGE INTERFACE 77
- Chapter 3 79
- 3.2.3 CONNECT TO DONGLE 81
- Chapter 4 89
- 4.1 CODABAR 90
- 4.1.3 CLSI CONVERSION 91
- 4.2 CODE 25 – INDUSTRIAL 25 92
- 4.2.2 VERIFY CHECK DIGIT 93
- 4.2.3 TRANSMIT CHECK DIGIT 93
- 4.3 CODE 25 – INTERLEAVED 25 95
- 4.3.2 VERIFY CHECK DIGIT 96
- 4.3.3 TRANSMIT CHECK DIGIT 96
- 4.4 CODE 25 – MATRIX 25 98
- 4.4.2 VERIFY CHECK DIGIT 99
- 4.4.3 TRANSMIT CHECK DIGIT 99
- 4.5 CODE 39 101
- 4.5.2 VERIFY CHECK DIGIT 102
- 4.5.3 TRANSMIT CHECK DIGIT 102
- 4.6 CODE 93 103
- 4.7 CODE 128 103
- 4.8 EAN-8 104
- 4.8.1 CONVERT TO EAN-13 105
- 4.8.2 TRANSMIT CHECK DIGIT 105
- 4.9 EAN-13 106
- 4.9.1 ISBN CONVERSION 107
- 4.9.2 CONVERT TO ISSN 107
- 4.9.3 TRANSMIT CHECK DIGIT 107
- 4.10 GS1-128 (EAN-128) 108
- 4.10.1 TRANSMIT CODE ID 108
- 4.11 MSI 109
- 4.11.1 VERIFY CHECK DIGIT 109
- 4.11.2 TRANSMIT CHECK DIGIT 109
- 4.12 FRENCH PHARMACODE 111
- 4.12.1 TRANSMIT CHECK DIGIT 111
- 4.13 ITALIAN PHARMACODE 112
- 4.13.1 TRANSMIT CHECK DIGIT 112
- 4.14 PLESSEY 113
- 4.14.1 CONVERT TO UK PLESSEY 113
- 4.14.2 TRANSMIT CHECK DIGIT 113
- Chapter 4 115
- Changing Symbology Settings 115
- Transmit Check Digit 116
- GS1 DataBar Expanded 117
- Transmit Code ID 118
- Transmit Application ID 118
- 4.16 TELEPEN 119
- 4.17 UPC-A 120
- 4.17.1 CONVERT TO EAN-13 121
- 4.17.3 TRANSMIT CHECK DIGIT 121
- 4.18 UPC-E 122
- 4.18.4 TRANSMIT CHECK DIGIT 124
- Chapter 5 125
- Chapter 5 127
- Defining Output Format 127
- 5.3.2 CHANGE CODE ID 130
- 5.3.3 CLEAR CODE ID SETTINGS 131
- 5.4 LENGTH CODE 132
- Chapter 6 137
- 6.1.2 EXCLUSIVE DATA EDITING 139
- End Programming Format 140
- 6.2.2 RESTORE DEFAULT FORMAT 142
- 6.3.1 APPLICABLE CODE TYPE 143
- 6.3.2 DATA LENGTH 147
- 137 149
- 6.4.2 FIELD SETTINGS 150
- 143 155
- Additional Fields 155
- Key Type Key Status 155
- 145 157
- 6.6 PROGRAMMING EXAMPLES 158
- 6.6.1 EXAMPLE I 158
- 147 159
- SPECIFICATIONS 161
- Appendix I 163
- Click [OK] 164
- USING BLUETOOTH 165
- DONGLE 165
- HOW TO UPGRADE 3666 FIRMWARE 167
- Appendix I Firmware Upgrade 169
- Enter Setup 170
- SN: SW3000014 170
- Appendix II 171
- EXAMPLE 172
- Appendix III 173
- KEY TYPE & STATUS 174
- KEY TYPE 174
- KEY STATUS 174
- Appendix IV 177
- HEXADECIMAL SYSTEM 178
- ASCII TABLE 179
- USE PRESET PIN 180
- DISABLE AUTHENTICATION 180
Produits connexes et manuels pour Lecteurs de codes-barres CipherLab 1266
(160 pages)
(277 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.033 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels