CipherLab 1562 Guide de l'utilisateur télécharger pdf (Page 129)

117

Chapter 4

Defining Output Format

4.2 CHARACTER SUBSTITUTION

“Character Substitution” replaces a character that comes up in a collected data whatever

the position is. Click on the “String” field to pop up the Grid Control window (see

Appendix I Grid Control). Into such “String” field, first assign the character to be replaced.

Following the previous character assigned to be replaced, in the same “String” field go on

assigning one or more character(s) to replace the foregoing character.

If only one character is assigned into the “String” field, the character will be gone from

the data collected when it identifies with the assigned character.

 The second character (and the character thereafter) assigned in the “String” field will

replace the first character.

 Up to three sets of character substitution can be configured.

Note: “Character Substitution” works for the collected data only and is applied before the

data goes through editing formats. “Character Substitution” is therefore not

applicable to the Prefix/Suffix Code, Code ID, Length Code, or any Additional Field.

The character “0” in the read barcode

ill be replaced by “Space”.

The character “9” in the read barcode

ill be replaced by “$9”.

The character “W” in the read barcode

ill be removed.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 159 160

Pas de commentaire

CipherLab 1562 Guide de l'utilisateur Page 129