CipherLab 1562 Guide de l'utilisateur télécharger pdf (Page 17)

Introduction

3. The scanner checks one by one whether the read barcode meets the criteria for a

concatenation of barcodes as configured on the Output Sequence page.

4. The scanner performs character substitution as defined on the Format Editing

page.

5. The scanner adds a 2-digit length code to the desired symbologies as selected on

the Code Length page.

6. The scanner adds a 1- or 2-character identifier to the desired symbologies as

selected on the Code ID page.

7. The scanner applies editing formats to the desired symbologies that meet the

criteria as configured on the Format Editing page.

8. The scanner adds a prefix/suffix code to the enabled symbologies as selected on

the Symbology page.

9. Finally the scanner outputs data via the desired interface.

5) If the scanner is connected to the host computer via RS-232 or Virtual COM

(Bluetooth SPP or USB VCOM), you can directly download the settings; otherwise you

need to click the

button on the menu bar to print out the setup barcodes to apply

the settings to the scanner by reading setup barcodes.

Note: The program PrintBarcode.exe must be in the same folder of ScanMaster.

6) When the scanner is configured successfully, connect it to the host computer via a

proper interface: Keyboard wedge, RS-232, Wand Emulation, Bluetooth HID,

Bluetooth SPP, USB HID, or USB Virtual COM.

Note: If the scanner is set to the Wand Emulation mode, you need to connect it to a

portable data terminal or a decoder that is expecting input from a wand scanner.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 159 160

Pas de commentaire

CipherLab 1562 Guide de l'utilisateur Page 17